Electronics and Wiring

The v1.6 Farmduino board features an Arduino MEGA 2560 microcontroller that interfaces with the Raspberry Pi and stepper drivers, and controls the ...

This NEMA 17 stepper motor comes with a pre-mounted rotary encoder. They are sold individually, and do not include any cables.

These cables connect the four rotary encoders to the Farmduino. Sold individually and as a set. Lengths: 0.7m (X1) 2.3m (X2) 2.7m (Y) 2.6m + 1.8...

These 4-wire cables connect each NEMA 17 stepper motor to the Farmduino. Sold individually and as a set. Lengths: 0.7m (X1) 2.3m (X2) 2.7m (Y) 2...

This 24V solenoid valve controls the flow of water from your garden hose to FarmBot's tubing. Compatible with Genesis v1.4+ and Express v1.0+ kits....

This USB cable provides power to the Raspberry Pi from the Farmduino's built-in 12v to 5v to USB circuitry. Connector 1: Right-angle USB 2.0 T...

This USB cable is used as a serial connection between the Raspberry Pi and the Farmduino Connector 1: Right-angle USB 2.0 Type A Male ...

This cable connects the solenoid valve to the Farmduino. For Genesis v1.3 kits, a 3m long cable is used. For Genesis and Genesis XL v1.4 kits, a 0....

Connects the Raspberry Pi to the Borescope Camera. Connector 1: Right-angle USB 2.0 Type A Male Connector 2: USB 2.0 Type A Femal...

These extra leads make it easy to connect new, additional peripherals to the Farmduino. Sold in packs of 2. Compatible with v1.3 and v1.4 Farmduino...

These connect the Grounded electronic pin to the Digital In pin, allowing FarmBot to detect when a tool has been mounted or dismounted correctl...

This PCB mounts directly onto the FarmBot Genesis Raspberry Pi GPIO pin header and provides connectors for the push buttons and LED indicators, as ...

The microSD card holds FarmBot OS and is inserted into the Raspberry Pi. Exact packaging may vary. Form Factor: MicroSD Capacity:...

This partial kit includes four NEMA 17 stepper motors with pre-mounted rotary encoders. It does not include any cables.

This rainproof box protects FarmBot's electronics from rain and debris. It features an easy-to-use tool-less double latch design for quickly openin...

These gold-plated pogo pins are attached to the Genesis v1.4+ UTM PCB and make electrical contact with FarmBot's tools. Included in this product is...

This fully-assembled electronics box features the Farmduino Express microcontroller, Raspberry Pi Zero W, and an E-stop button.

This 24V vacuum pump sucks air through the seeder’s luer lock needle in order to suction-hold a seed on the needle tip during planting. It featu...

The v1.4 - v1.5 UTM PCB features a custom matte-black finish. Note: pogo pins and plastic UTM part are not included.

This two-part cable connects the vacuum pump with EMI filter to the v1.6 Farmduino. The cables feature a 90-degree waterproof screw-together connec...

This two-part cable connects the UTM to the v1.6 Farmduino. The cables feature a 90-degree waterproof screw-together connector between the Y-axis a...